The Phantom from Titanfall 2, 3D printable and fully articulated. Featuring moveable wings(?), openable canopy with a cockpit interior, pivotable thrusters, rotating guns, and nonfunction landing gear!
No screws or glue necessary, though maybe some sanding and scotch tape.
For the parts that need supports, I recommend using tree supports.
Print one of every piece except for straton exploded, except for the ones with _x# at the end, in that case print that amount of the piece. So print 2 wing panels, 2 clips, 2 guns, 2 tail bases, and 4 thrusters, but one of everything else. Don't print straton_exploded, that's just for reference.
| stratonprint_canopy.stl | 141.9KB | |
| stratonprint_clip_x2.stl | 8.3KB | |
| stratonprint_front_landing_gear.stl | 52.3KB | |
| stratonprint_gun_x2.stl | 46.2KB | |
| stratonprint_hull_front.stl | 337.6KB | |
| stratonprint_hull_mid.stl | 95.2KB | |
| stratonprint_hull_rear.stl | 79.5KB | |
| stratonprint_l_hull_side.stl | 175.7KB | |
| stratonprint_l_tail_wheel.stl | 39.2KB | |
| stratonprint_l_wing.stl | 91.6KB | |
| stratonprint_rear_landing_gear.stl | 55.4KB | |
| stratonprint_r_hull_side.stl | 175.7KB | |
| stratonprint_r_tail_wheel.stl | 39.2KB | |
| stratonprint_r_wing.stl | 91.6KB | |
| stratonprint_tail_base_x2.stl | 22.7KB | |
| stratonprint_thruster_x4.stl | 82.9KB | |
| stratonprint_wing_panel_x2.stl | 24.9KB | |
| straton_exploded.stl | 1.9MB |
