Tire Valve Cap, A Bit Smaller For You To Twist And Adjust Better. 3D Printer Model

Author: @
License: CC BY-NC-SA
File formats: stl
Download type: zip
Size:198.3KB

The file 'Tire Valve Cap, A Bit Smaller For You To Twist And Adjust Better. 3D Printer Model' is (stl) file type, size is 198.3KB.

Summary

First I made the cap flat, without the logo.
But the cap was loose, was a little big.
Then I reduced the diameter from 10.5 mm to 10 mm.
Fitted well, but if you screw until the end the air comes out, because the cap touched the needle valve.
Finally I made a dome so that the cap did not touch the needle.

Primero hice el tapón plano, sin logo.
Pero el tapón quedaba con holgura, un poco grande.
Despues le reduje el diametro de 10.5 mm a 10mm.
Ajustó bien, pero si enroscabas hasta el final se salia el aire, porque el tapón tocaba la aguja de la valvula.
Finalmente hice una cupula para que el tapón no tocase la aguja

Valve_Cap_d10.stl 479.0KB