Description Files (10)

Summary

Updated Version

Changes

V2
- Increased Range
- Easier to print (no barrel section)
- Smaller in size (due to no barrel and 8 rounds in magazine instead of 9)
- Easier to assemble (More space for bands, looser tolerances, and thicker, easier to insert clips/tabs)
- Easier trigger pull (I realized I had a misconception of what was caused the bbs to go faster and added a relief for the magazine lips flexing.

Dinky little toy blaster. it shoots about 20 feet, is pretty small and is made out of purely printed plastic and two rubber bands (One for the trigger and one for the magazine).

It requires no fasteners, or glue, and just uses printed tabs to connect the clam shell case.

It uses less than 45 grams of filament, can be printed in PLA and has only one part that uses supports, (that are easy to remove on the trigger).

The magazine clicks in and is pulled out the same way

It fires 6mm airsoft bbs

Blaster_Launcher_Assembly_-_Barrel.stl	490.0KB
Blaster_Launcher_Assembly_-_Bolstracikter.stl	24.2KB
Blaster_Launcher_Assembly_-_Bolstracikter_Pin.stl	20.4KB
Blaster_Launcher_Assembly_-_Case_Left.stl	1.5MB
Blaster_Launcher_Assembly_-_Case_Right.stl	1.6MB
Blaster_Launcher_Assembly_-_Trigger.stl	480.1KB
Blaster_Magazine_Assembly_-_Magazine_Body.stl	604.3KB
Blaster_Magazine_Assembly_-_Magazine_Follower.stl	32.6KB
Blaster_Magazine_Assembly_-_Magazine_Rear_Cover.stl	73.7KB
Blaster_Print_Oriented.stl	4.7MB

Tiny Toy Blaster (6mm Airsoft Toy Gun) 3D Printer Model

Summary

Updated Version

Changes

Tags

You might also like