Tiny Servo Driven FPV RC Tank – Tiny Trak 3D Printer Model
The file 'Tiny Servo Driven FPV RC Tank – Tiny Trak 3D Printer Model' is (stl) file type, size is 578.5KB.
The file 'Tiny Servo Driven FPV RC Tank – Tiny Trak 3D Printer Model' is (stl) file type, size is 578.5KB.
This tiny FPV Tank uses Lego tracks driven by servos. To build you need the following:
Print:
The frame is printed with integrated supports. See image for removing the supports prior to final assembly. Cut off the servo arm to fit into the driven wheel and attach using supplied screw. The non driven wheels can be attached by M3 bolts and spacer. If printing the wheel halves, just super-glue together. Frame and Chassis snap together. Super-glue the FPV pod to the top of the frame.
UPDATE: I ordered bright white LEDs and it was too much light. Updated file for only one central LED. if your lights are not a bright, then go with the two.
UPDATE: I apparently forgot to upload the three wheel chassis. that has been remedied.
Video at https://youtu.be/3xX55TlleuA
https://www.youtube.com/watch?v=c7dHLBPiJa4
See my other Tiny Traks here:
https://www.thingiverse.com/thing:3464889
https://www.thingiverse.com/thing:3481012
| Camera_Pod.stl | 283.5KB | |
| Drive_Wheel_A.stl | 344.2KB | |
| Drive_Wheel_B.stl | 482.4KB | |
| Drive_Wheel_Whole.stl | 91.3KB | |
| Non_Drive_A.stl | 272.5KB | |
| Non_Drive_B.stl | 378.2KB | |
| Non_Drive_Wheel_Spacer.stl | 28.2KB | |
| Non_Drive_Wheel_Whole.stl | 81.1KB | |
| Tank_Chassis.stl | 367.4KB | |
| Tank_Frame_Front_Half.stl | 533.5KB | |
| Tank_Frame_Rear_Half.stl | 381.5KB | |
| Tank_Frame_Whole.stl | 994.7KB | |
| Tank_Frame_Whole_-_OneLED.stl | 1.0MB | |
| three_wheel_chassis.stl | 96.5KB |
