Tilt Stand V2 For Tecsun PL-880 Radio Receiver 3D Printer Model
The file 'Tilt Stand V2 For Tecsun PL-880 Radio Receiver 3D Printer Model' is (stl,scad) file type, size is 227.0KB.
The file 'Tilt Stand V2 For Tecsun PL-880 Radio Receiver 3D Printer Model' is (stl,scad) file type, size is 227.0KB.
Version 2.0 uses less plastic.
The fragile fold-out stand on the back of the Tecsun PL-880 radio is prone to breakage, and it's 25-degree tilt angle wasn't enough for the antenna to stick directly upwards (which limited how close I could place the radio against the wall with the antenna extended). I didn't like the viewing angle in any case.
So, here is a customizable tilt stand for said radio (default angle 55-degrees), or perhaps for other devices such as a tablet. Default width of 154mm was selected to fit between the rubber feet of the Tecsun PL-880. Tilt angle is not adjustable after printing, but I didn't need it to be.
| tecsun-stand-v2-55.stl | 1.7MB | |
| tecsun-stand-v2.scad | 3.3KB |
