Modeled up the new leaked pass for Pokemon Go. Lets see what happens on November 2nd.

Edit: After printing and attempting to put the cover on the raid body, the curve is causing a bit of an issue. It is possible to get them together but you will need to put the top corner in first and then push the bottom part in. It will be a bit difficult but doable. I will try to adjust the model to compensate for this at a later time. Once they are together you will likely not be able to get them apart. Paint and finish before assembly.

Version 2 has been uploaded. Its a bit easier getting the cover seated but it still gets locked into place. You will still need to paint and finish before adding the cover unless you want a plain print. Working on version 3 since I want to be able to remove the cover easily so I can add small LEDs to make is glow a bit when using it.

Version 3 is done. Printed and confirmed although it clicks into place it can still be pulled apart from the cover. Use this file if you plan on adding lights to your print. Version 1 or 2 can be used if you plan on using a static print with no lights.

Final print shown in pic, version 3. I used the 2032 battery holder from https://www.thingiverse.com/thing:48606 and some small Christmas LEDs covered in hot-glue.

Have fun printing.