All the shafts are ∅2mm (waxed for a smoother clock).
The Crank is simply glued on the weight support.
I added spaces to glue weight on the pendule's back, I used 2 M8 bolt, one at the top and one at the bottom (adjust the height for better results).
I used skateboard bearings for the weights, 3 or 4 should work just fine.
Print the base oriented like it is when built, no support required.
Make sure that every spinning parts are moving freely !
HAVE FUN !
| Base.STL | 592.5KB | |
| crank.STL | 161.0KB | |
| Escapement_Anchor.STL | 739.2KB | |
| Escapement_Wheel.STL | 424.1KB | |
| Link_Pendule_to_anchor.STL | 109.7KB | |
| Pendule.STL | 500.5KB | |
| Weight_support.STL | 118.4KB | |
| Wheel.STL | 1.4MB |
