Well first of all this is not my design, it was made by: @gloomeskk but I edited it a bit so you can put a light on it.
I strongly recommend to scale it from 100% to 150% of size because the head has a lot of details and with the hole on it the printer could leave some unwanted holes. I don't know what would happen if you use a resin printer bc I don't have one.
Other reason for the bigger scale is for the leg because i think that in 100% of size the holes may be a little small for the wires to pass through it.
The supports were only used in the parts that are touching the bed, not everywhere but you can choose what you feel better with.
I only used raft for the Wire thing just to make sure it doesn't fell and added a custom support.
The full model is from here
https://sketchfab.com/models/34acb03c841247d28aaa80204f1f52b2
And the designers page is here
https://www.thingiverse.com/gloomeskk/designs
You can follow me on IG if you like, there you will see the Thunderjaw painted and working :)
https://www.instagram.com/fraguadelmultiverso/?hl=es
| Antenna_LeftPrint_2_of_these.stl | 2.5MB | |
| Antenna_RightPrint_2_of_these.stl | 2.5MB | |
| Antenna_SupportPrint_2_of_these.stl | 94.8KB | |
| A_Thing_That_Goes_In_The_Back_Of_The_Head.stl | 570.6KB | |
| Body_Bottom_Hollow.stl | 524.6KB | |
| Body_Top_Hollow.stl | 1.1MB | |
| Head_Hollow.stl | 806.1KB | |
| Left_Leg_Low.stl | 6.7MB | |
| Left_Leg_Top.stl | 9.7MB | |
| Neck_bottom_hollow.stl | 784.8KB | |
| Neck_Top.stl | 8.7MB | |
| Right_Leg_Low.stl | 490.4KB | |
| Right_Leg_Top.stl | 497.7KB | |
| Tail_Left.stl | 7.7MB | |
| Tail_Right.stl | 7.8MB | |
| Wire_Left.stl | 1.9MB | |
| Wire_Right.stl | 1.3MB |
