I made this becouse my joystick became sticky so i needed to cover them up. But at the same time i didnt want to raise them up too much.
On the original file ton of people complained that the cap is rubbing on the controller.
So i shortened it by 1mm and uploaded it and also shortened the original one. But printing the original one in TPU isnt the best becouse of the overhang.
| Thumbstick_Cap_PS4_Original_No_Rub.stl | 368.8KB | |
| Thumbstick_Cap_PS4_Ring.stl | 302.8KB | |
| Thumbstick_Cap_PS4_Ring_Smaller.stl | 251.9KB |
