Throwing Star Wolf Moon Crescent 3D Printer Model
The file 'Throwing Star Wolf Moon Crescent 3D Printer Model' is (stl) file type, size is 526.7KB.
The file 'Throwing Star Wolf Moon Crescent 3D Printer Model' is (stl) file type, size is 526.7KB.
This throwing start is one of my longest and toughest designs so far, every single curve and side had its own unique problem that I had to overcome. This is my second time designing this star since the first one was unable to be fixable and also lost the file and had to start from scratch again. I have doubts about the actual usability of this star but I just really like the design of this. I will be printing this off and will give my own feedback on how it works out and if it is strong enough to use. I would greatly appreciate any negative or positive feedback on the design and the solid form of this star.
Enjoy
Directions
If you want to make the full throwing star, print off both sides of the principal then with fine sandpaper smooth down the bottoms of both sides, use a type of epoxy or other method of sticking them together and let them harden, then sand down excess epoxy, and smooth out the rest if desired.
If you are using it as a wall hanger or display piece you may only want to print off the one side so it will sit flush against a wall or other display.
| throwing_star_side_one.stl | 650.8KB | |
| throwing_star_side_two.stl | 650.8KB |
