Shot dispenser for my boat, hole diameter for glasses are 44mm, or 1.73228346 inches.
Its mate theaded for ease of stowing away, since it is to be used on a sailboat.
Upper must be oriented with threaded part down,
Lower should be orieted upside down, for less support.
Nut is either way i prefer upside down for ease of printing.
PS: Only printed once, but print settings under was used with good result
Support should be set to 50+ degrees, i have mine set for 65,
Support removal on the nut, I recommend using a small screw
| ShotDispenser_Threaded_Lower_v1.stl | 634.8KB | |
| ShotDispenser_Threaded_nut_v1.stl | 451.5KB | |
| ShotDispenser__Threaded_Upper_v1.stl | 1.1MB |
