Wanted to mount my laptop under my desk for work, so printed these. They all fit fairly snug on my laptop.
In fact, after I printed the "left" holder, I realized I can't slide my laptop in/out since the back of the laptop is a little larger than the front. For the "right" holder I made some rails so it can slide in and out to fit the laptop in it. For the right holder I would suggest using a higher infill since I made the top plate too small - my 15% infill one cracked. It is supporting a laptop so they should all probably be higher anyway.
To hold these underneath the desk I'm using heavy-duty 3M mounting tape. It seems to hold up fine but no guarantees. My tape gave and crashed, so would suggest screwing it in. Could screw it to the underside if you're concerned and want a more permanent solution.
| back-holder.stl | 47.7KB | |
| left-holder.stl | 31.1KB | |
| rail.stl | 3.6KB | |
| right-holder-rail.stl | 32.5KB |
