THE M&M VAULT: The Mass-Storage Solution For M&M's And Skittles 3D Printer Model
The file 'THE M&M VAULT: The Mass-Storage Solution For M&M's And Skittles 3D Printer Model' is (stl) file type, size is 494.2KB.
The file 'THE M&M VAULT: The Mass-Storage Solution For M&M's And Skittles 3D Printer Model' is (stl) file type, size is 494.2KB.
Sometimes the little M&M packets aren't enough for you. The M&M's fall out, and there's only so many. To solve this previously unavoidable problem, I have designed this M&M vault that can hold up to 56 M&M's!
There are four drawers that pull out from the main cask, each supporting 14 M&M's. There is also a screw on top that is not very obvious, so thieves will not be able to steal your priceless M&M's.
This was a rather large undertaking for me, but it won't be for you. Since this is a simple print, any printer should be able to print it. The M&M's were measured carefully and given a generous clearance (The M&M's weren't put to waste, they were eaten afterwards).
| MM_Drawer_Holder_v6.stl | 266.9KB | |
| MM_Holder_Drawer_v11.stl | 1.3MB |
