This is a saxon / dark ages mill designed for the 28mm wargames tabletop, but which can be used as a stand-alone/educational model. The building could also be used without the mill workings as a wharfside warehouse, and I have also included a blank rear wall so that the parts can be used to create a standard wooden hut (pictured)
It is based (with a large dose of poetic licence) on the archaeological finds as pictured on the Regia Anglorum site https://regia.org/research/village/acmylen.htm , which I then took liberties with.
For example I may have just invented the saxon sliding door!, but my rationale is that sliding doors are cheaper than hinges, and doable if there isn't a blacksmith handy.
The mill comes with a river section designed to be used in conjunction with my Modular Water sections ( http://www.thingiverse.com/thing:2097314) but I have included a plain mill race if the mill is for stand-alone use. I also include small supports for under the piles so you can adjust the height of the mill if you are using your own river/stream sections.
Please note that the model comes with a grain hopper and support for controlling the flow of the grain into the mill grinding wheel, but they are not included in my photos as I thought they were a bit ott for a wargames model.
Oh - there's also a couple of flour bags to chuck round the model
| boards_1.stl | 175.4KB | |
| bot_rail1.stl | 4.9KB | |
| frontdoor_1.stl | 92.2KB | |
| fullbag1.stl | 2.0MB | |
| grinder_1.stl | 233.1KB | |
| grinder_2.stl | 228.0KB | |
| halfbag1.stl | 3.7MB | |
| hopper1.stl | 954.6KB | |
| hop_frame1.stl | 263.3KB | |
| hutwall1.stl | 17.2KB | |
| jettybase1.stl | 610.6KB | |
| jettyplanks1.stl | 119.7KB | |
| mill_base1.stl | 211.2KB | |
| paddle_wheel1.stl | 292.8KB | |
| porch_1.stl | 82.9KB | |
| porch_roof_1.stl | 5.0KB | |
| race1.stl | 3.8KB | |
| river1.stl | 8.7MB | |
| riverdoor1_2.stl | 129.6KB | |
| roof1_2.stl | 21.6KB | |
| sidewall1_4.stl | 122.2KB | |
| slide_door1.stl | 21.7KB | |
| steps1_2.stl | 7.9KB | |
| step_to_boards_link1.stl | 3.0KB | |
| support_1.stl | 91.5KB | |
| top_rail1.stl | 3.0KB |
