The Clarm – Fully Modular Helping Hand 3D Printer Model
The file 'The Clarm – Fully Modular Helping Hand 3D Printer Model' is (stl) file type, size is 15.8MB.
The file 'The Clarm – Fully Modular Helping Hand 3D Printer Model' is (stl) file type, size is 15.8MB.
My goal with this project was to make a set of helping hands while soldering that can be fully 3d-printed and modular.
The result became "The Clarm"
Clarm doesn't require any parts that can't be 3d-printed, no supports, just press print and you're done. You might want to print all the parts in two sessions though.
Some parts have quite a small area touching the build plate, this can become a problem for some printers. In that case you might want to add a raft to those parts.
Clarm is made up of a couple of joints and spacers, apart from the base and the claw. Just add as many joints and spacers you want for your Clarm. If you're not sure how to configure your Clarm you can pick the stl-files labeled "clarm_base_configuration_print1" and "clarm_base_configuration_print2".
| 4X | inner_thread_to_inner_ball
| 4X | outer_ball_to_inner_ball
| 4X | ball_tightener
| 1X | Evetything else
I intend to add additional claws and useful stuff that can be attached. This is a WIP and I would very much appreciate your feedback and suggestions.
And if you print this, please do a make of it and let me know how it turned out =)
| ball_tightener_v80.stl | 2.5MB | |
| base_tightener_v80.stl | 1.7MB | |
| base_v80.stl | 412.4KB | |
| clarm_base_configuration_print1_100infill_v80.stl | 20.2MB | |
| clarm_base_configuration_print2_15infill_v80.stl | 7.6MB | |
| claw_fixed_v80.stl | 343.8KB | |
| claw_mobile_v80.stl | 124.5KB | |
| claw_tightener_bolt_v80.stl | 1.6MB | |
| claw_tightener_v80.stl | 503.6KB | |
| cyl_cyl_joint_v80.stl | 713.5KB | |
| inner_thread_to_inner_ball_v80.stl | 1.3MB | |
| outer_ball_to_inner_ball_v80.stl | 1.8MB | |
| outer_thread_to_inner_thread_v80.stl | 924.4KB |
