The 1/64 Diecast Car N-Lanes Starter Box 3D Printer Model
The file 'The 1/64 Diecast Car N-Lanes Starter Box 3D Printer Model' is (stl,f3d) file type, size is 3.1MB.
The file 'The 1/64 Diecast Car N-Lanes Starter Box 3D Printer Model' is (stl,f3d) file type, size is 3.1MB.
"THE N-LANES DIECAST CAR STARTER BOX" can be used as a starter for a multi lane diecast car race track. Just print as many boxes as you like and connect them with the connector piece. I have tested 4 Lanes so far which works quite nicely.
Print settings:
track: 10% Infill. print upright with raft. no supports
lid: print outside downwards
thestick: no special settings
starter: print on the side with 20% infill supports from the bed
lever: print upright on the side with 20% infill and supports
box: print upright. thin walls shouldnt be too worried about infill. might aswell use 100%
knob.stl: no special settings. wider end to the bed...
For assembly I used four M4 with M4 inserts to fix the track and close the box.
Also four M4 screws and nuts to connect the boxes.
1 short and one long connector plus 8 washers per connected 2 boxes.
Enjoy,...
| box.stl | 164.9KB | |
| box_v2.stl | 173.9KB | |
| connector_short.stl | 684.0B | |
| connector_v2.stl | 684.0B | |
| knob_v2.stl | 483.7KB | |
| knob_v3.stl | 352.1KB | |
| lever.stl | 100.9KB | |
| lid_v2.stl | 21.0KB | |
| starter.stl | 76.4KB | |
| StarterBox_v62.f3d | 2.8MB | |
| thestick.stl | 28.9KB | |
| thestick_long4.stl | 53.8KB | |
| track_v2.stl | 87.7KB | |
| washer.stl | 34.8KB |
