This is a little station that holds the TFV-18 drip tips I designed. One model is just for the tips, the other includes a spot for my Geek Vape Aegis mod.
Layer Height - .2mm or .1mm for better quality on the top layers(maybe ironing as well?)
Infill - 15%
Walls - 4
Supports - No
Raft/Brim - No
Apologies for the model's pictures, I used some Makerbot translucent purple PLA that's about 9 years old(I have a lot and use it for firing off prototypes. It doesn't show the model off well. I may swap the photos once I print my final model and paint the lettering black(still debating on the color). I also didn't clean up the print afterwards since they're just junk prototypes. If printed slow at .1mm layer height you should get decent results.
This was printed on a CR10-SE @ 300mm/s past layer 2.
Bottom layers were at 100mm/s.
| DripTipStand.stl | 501.6KB | |
| DripTipStandWAegis.stl | 550.1KB |
