Printed in Cura.
I modified it a little in Cura, so the one in the photo is not as slim in the mode. I reduced its hight to make it slimer like a coin, and made it a big wider on the other axis. The specific dimensions I set it at were X: 120mm, Y: 120mm, Z: 11.620mm.
I printed it slightly midair with automatic tree supports and the no-supports cubes to avoid branches forming on the front side, with the medal slowed to some 75 to 80 degrees. the modifier cube in the middle of the medal is to make a gap in the support wall on the back to facilitate the use of a tool to separate the print from its support, given that I used a reduced Support X/Y Distance setting on this print. not sure if it was necessary to use that setting, so experiment if you want.
my settings:
-0.9 layer hight
-3 walls
-8% gyroid infill
-15% gyroid tree supports with a Support X/Y Distance of 0.31mm
-ironing enabled with an Iron Inset of 0.1mm
| sun_coin.stl | 125.9MB |
![Sunlight Straight Sword [Dark Souls III] (Fixed Version) 3D Printer Model](https://cdn.3axis.co/assets/70/8e/35/42/708e3542-f16f-4af2-af99-c7e6a1f589fd/images/42067847-5f08-4837-9ba6-e58f9a6b4d12_thumb.jpg)
