Tevo Tarantula Case Mk1 3D Printer Model
The file 'Tevo Tarantula Case Mk1 3D Printer Model' is (stl) file type, size is 965.6KB.
The file 'Tevo Tarantula Case Mk1 3D Printer Model' is (stl) file type, size is 965.6KB.
A case for the Tevo Tarantula 3D printer - http://tevoprinter.com/
In this case, you can attach the MKS base 1.2 board. Power is supplied by a micro ATX PSU. Two slots for 80mm cooling fans are also provided.
No opening for the SD card in this version, because I use OctoPrint and the Raspberry Pi is also in the case.
You need to use reset button from Kossel Mini SmartLCD-Case by schlotzz - http://www.thingiverse.com/thing:320117/#files
Dimensions of the assembled case:
width: 18cm
height: 19cm
depth: 16cm
Needed (optional) :
Update #1 - Adding four new panels: whole panel and without fan grid
Update #2 - A new rear panel with holes fixations for a micro ATX PSU board (110x85mm for holes)
Update #3 - A new left panel with a hole for the SD card
Update #4 - A new top panel with holes for attach a Raspberry Pi
Update #5 - A little improvement in the ventilated rear panel
Update #6 - A new left panel with holes to attach a little relay module
Update #7 - A new right panel with shorter aerations to let you attach any module
| base.stl | 134.4KB | |
| button.stl | 166.5KB | |
| front_bottom.stl | 608.1KB | |
| front_bottom_without_fan_grid.stl | 323.1KB | |
| front_top.stl | 269.6KB | |
| left_panel.stl | 335.6KB | |
| left_panel_with_sdcard_hole.stl | 347.0KB | |
| left_panel_with_sdcard_hole_and_relay.stl | 405.6KB | |
| micro_atx_rear_panel.stl | 142.3KB | |
| rear_panel.stl | 128.2KB | |
| reprapdiscount_lcd_box_button.stl | 101.3KB | |
| right_panel.stl | 335.6KB | |
| right_panel_with_short_aerations.stl | 336.6KB | |
| top.stl | 393.7KB | |
| top_without_fan_grid.stl | 120.2KB | |
| whole_front_bottom.stl | 272.2KB | |
| whole_top.stl | 46.8KB | |
| whole_top_with_rpi.stl | 160.0KB |
