These mounts hold the Tesla NASC / J 1772 adapter. Built this because I often set the adapter down when going between Tesla and the Volt, and then had to search for it. Now, the adapter is found in its holster right next to the charger.
Two models are uploaded here:
PLA print time using the GCode uploaded here is about 2.5 hours. Came out just fine.
ABS print time is about 3.5 hours. Haven't printed this one yet.
GCode was generated by Cura 5.7.1
Designed in Fusion 360
| Tesla_adapter_holder_wall_mount.stl | 265.7KB | |
| Tesla_adapter_holder_zip_tie.stl | 548.4KB | |
| Tesla_adapter_zip_tie.gcode | 5.5MB | |
| Tesla_zip_tie_ABS.gcode | 4.6MB |
