Tesla Model 3 Jack Pad Hockey Puck Adaptor 3D Printer Model
The file 'Tesla Model 3 Jack Pad Hockey Puck Adaptor 3D Printer Model' is (stl) file type, size is 44.5KB.
The file 'Tesla Model 3 Jack Pad Hockey Puck Adaptor 3D Printer Model' is (stl) file type, size is 44.5KB.
Since I thought that grapha3d's design was beautiful and practical but did not trust neither ABS nor Nylon to not act as an abrasive on the car itself, I took the tip, made a hole in it and added two fittings for either a 8mm or 10 mm nut so that you can use whatever bolts you have lying around and screw the tip onto either a rubber hockey puck or a generic jack pad - as I have done. This can be printed in almost any material since it only guides and holds the load bearing puck in place.
| Puck_center_star.stl | 8.9KB | |
| Tesla_hockey_puck_adaptor.stl | 112.0KB |
