Storage solution for Terraforming Mars board game.
** UPDATE: 25 Jun 2018: Fix height of both TM_Box_Inner_One and Two.
** UPDATE: 7 Sep 2017: Sleeved Card Support
I'm personally not use card sleeve but I understand that many of you will need it.
Now the storage solution is sleeved card support. You need to print the file TM_Card_Sleeve.stl instead of TM_Card. No need to print TM_Card_Fill.stl and TM_Inner_One.stl. You might need to print file TM_Inner_Wall.stl to put inside the big box. Keep some card like corporate card in the big box. The rest goes to TM_Card_Sleeve.
You need to print 1 copy of every STL file except the S-box that you need to print it for 3-5 copies as you need. Details of insert setting are below.
S-Box is for store player cubes seperately. Actually it need 5 copies of box and lid. They will fill up the game box perfectly.
But in case you also need to have some card holder. You may print it only 3 sets of S-Box and lids and use the Inner_One and Two for store 2 remaining player cube sets.
Twelve of my card holders are perfectly replace those couple S-boxes as my picture show you (Download it here: https://www.thingiverse.com/thing:2446046).
For people who store game box vertically. You will need some foam core or thick card board to fill up the box for boxes lid will not acidentally open. Or you could use cylinder magnet size of 3mm diameter x 3.75mm height to make them stick together.
B-Ramp is not required but if you play solo a lot you can print it and insert it in the inner slot inside the Big Box. You can use the small slot in the big box to store your player cubes. The B-Ramp will help you to easier pick up those cubes.
| TM_B-Ramp.stl | 44.1KB | |
| TM_BigBox.stl | 310.3KB | |
| TM_BigBox_Lid.stl | 174.5KB | |
| TM_Card.stl | 208.8KB | |
| TM_Card_Fill.stl | 157.7KB | |
| TM_Card_Sleeve.stl | 236.4KB | |
| TM_Hex.stl | 58.5KB | |
| TM_Hex_Fill.stl | 95.8KB | |
| TM_Hex_Lid.stl | 47.2KB | |
| TM_Inner_One.stl | 63.0KB | |
| TM_Inner_Two.stl | 63.1KB | |
| TM_Inner_Wall.stl | 64.2KB | |
| TM_S-Box.stl | 219.2KB | |
| TM_S-Box_Lid.stl | 176.7KB | |
| TM_S-Ramp.stl | 35.1KB |
