Based on the Byodoin temple. Test printed for fdm. Some problems with lifting corners on the base and top floor, but nothing some masking tape to hold it down wouldn't have fixed, and that could just have been the filament I was using, as there were no issues once I switched to the red.
| base_L.stl |
| base_R.stl |
| bird_topper.stl |
| center_floor.stl |
| guardian_1.stl |
| inner_wall_back.stl |
| inner_wall_front_L.stl |
| inner_wall_front_R.stl |
| inner_wall_L.stl |
| inner_wall_R.stl |
| ladder.stl |
| lantern.stl |
| lightpost.stl |
| lower_roof_L.stl |
| lower_roof_R.stl |
| outer_wall_back_L.stl |
| outer_wall_back_R.stl |
| outer_wall_front_L.stl |
| outer_wall_front_R.stl |
| outer_wall_L.stl |
| outer_wall_R.stl |
| roof_strut_L.stl |
| roof_strut_R.stl |
| stairs.stl |
| trapdoor.stl |
| upper_beams.stl |
| upper_floor.stl |
| upper_roof_L.stl |
| upper_roof_R.stl |
| upper_wall_back.stl |
| upper_wall_front.stl |
| upper_wall_L.stl |
| upper_wall_R.stl |
