This is my personal design of a RC car in 1:26 scale (approximately).
All things are designed and printed by me in solid translucent blue PLA on my Ultimaker. Only 0.5 module 49 tooth gear was printed in yellow PLA.
For the car electronics I used an Arduino Mini compatible board, a Pololu DRV8835 motor driver and a rf24 2Euros RC module. The steering is commanded with a Hitec HS-55 feather servo.
The controller is made with a PS2 dualshock controller, another Arduino (Nano) and another rf24 module.
I have not printed the body car yet because the electronic is "fat"...
Great RC car, my ultra hard tire give the ability to do great drift!
Here there is a video of the controller:
and making some drift:
I hope you enjoy. I am here for every question
Bye.
GCopper
20131201: Added sketches
20131202: Added mechanical BOM and step assembly
| ASS_1E26_CAR.stl | 12.0MB | |
| ASS_1E26_CAR.stp | 2.0MB | |
| ASS_MOTOR.stl | 499.9KB | |
| ASS_STEERING.stl | 474.6KB | |
| BATTERY_HOLDER_2XAA.stl | 660.0KB | |
| FRONT_BOTTOM_CHASSIS.stl | 699.6KB | |
| FRONT_TOP_CHASSIS.stl | 263.8KB | |
| FRONT_WHEEL_HUB.stl | 1.2MB | |
| Spur_Gear21.stl | 329.4KB | |
| Spur_Gear21_02.stl | 374.8KB | |
| Telaio_1e26_ArduinoSkecthes.zip | 4.2KB | |
| Telaio_1e26_BOM.xls | 60.0KB | |
| Telaio_1e26_MechanicalBOM.pdf | 186.2KB | |
| TEST_WHEEL.stl | 174.7KB |
