W A R N I N G :

This project has been completely reviewed and enhanced in:

Pipe connector (1 to 6 pipes) highly customizable < < < < < < < < < < <

https://www.thingiverse.com/thing:4192048

==================================================================
Fully customizable tee pipe connector.

Using the customizer, you can select:

• external diameters of the 3 pipes, individually
• internal diameters of the same, individually
• individual lengths of the 3 pipes, anf of the insert section

The diameter of the inside junction can be defined.

The pipe extremities are rounded.

A test parameter allows to look inside the connectot.

Use support as needed when printing.

Enjoy !

With Tee4, THE ANGLES ARE FREE ! <<<<<<<<<<<<<<<

but stay on Tee3 for a pure flat Tee.

========================================================

T3cross is a derivative of Tee3 with a "cross" parameter. It mirrors the transverse pipe to get a 4-way cross. This a flat (no free angle) version.

======================================================
T3full:
gives access to full parameters of a flat version (but no angle liberty): USE ONLY IF YOU NEED IT

New parameters:
test: more cuts to look inside 0, 1, 2, 3
FT : enable separate borings DT (for one or 2 transverse, DL (left part),DR (left part)
SP: cut an internal sphere at the junction point

========================================================
Tee20.stl is already configured for a tee with 20mm internal diameter and a high resolution.