These caps are designed to fit the ISO standard automotive valve stems used on most cars, light trucks and motorcycles.
Most should print without supports unless noted below.
THIS VERSION WILL REQUIRE SUPPORTS AND I WOULD GO 20-30% INFILL.
Due to the properties of different filaments and temperatures, etc, I recommend printing one to make sure it fits properly. You may have to scale up/down a tad. My test prints with PLA+ fit nicely with no adjustments.
I recommend printing at .15 line height due to the 32tpi on the threads.
If you like this remix, check out the original models listed in the left sidebar.
If you want to see all the valve stem caps I have remixed:
https://tinyurl.com/qnd82kz
I have designed over 500 remixes of various types. If you want to search by the type, visit my profile: https://www.thingiverse.com/ToaKamate/about
Teddy-Bear-Cap.stl | 12.5MB |