I needed a launch ramp for my Tech Deck and found no good ones online so I decided to make my own!
good luck printing it, for maximum efficiency print at as seen size when in your software
For my Ender 5 I had to print it at 85% size so I could fit the skirt into the build plate
I have NOT tested the middle section to see if all the parts clip together, so if you do try it let me know how it goes and where its wrong, and let me know if it works first try!
| JustRamp.stl | 400.6KB | |
| LeftRamp.stl | 444.8KB | |
| MiddleRampoptional.stl | 3.4MB | |
| RightRamp.stl | 446.3KB | |
| TechDeckRampFull.stl | 4.3MB |
