I recently uploaded a modular and customizable lithophane lamp:
https://www.thingiverse.com/thing:4697707/
In case you want to change a single lithopane on that lamp, I designed this little tealight stand for a single lithopane so you don't have to throw it away.
Lithopane:
I've used the following site to create the lithophane: http://3dp.rocks/lithophane/
Make sure to use a picture with a 1:1 ratio
On the website select "outer curve" model
Set your model settings to maximum size 100mm, thickness 3mm and border 3mm
Also choose "positive image" in the image settings
Set Curve to 85
I made the radius of the groove a little bit smaller than the radius of the lithophane so that it has a nice tight fit.
Let me also know if you have any suggestions!
| lithophane_tealight_holes.stl | 162.8KB |
