This is a new model based on the design of https://www.thingiverse.com/thing:4763805
There are some errors in that model so I recreated it.
You can load the models that I created in you preferred slicer with your stock settings and just press print.
The model says it has parts that are too thin. Just ignore the message. Slice the models and check the layers for yourself. All will be OK.
-No supports needed (tested with 0.6mm nozzle)
-If needed, sand the corners on the mounting plate and where it slides on the base.
-Fit the mounting plate with two screws or double sided tape.
Now enjoy a nice cup of tea!
| Teabag_holder.stl | 23.1KB | |
| Teabag_holder_-_base.stl | 17.7KB |
