Tattoo Machine Ink Pen 3D Printer Model
The file 'Tattoo Machine Ink Pen 3D Printer Model' is (skp,stl) file type, size is 1.1MB.
The file 'Tattoo Machine Ink Pen 3D Printer Model' is (skp,stl) file type, size is 1.1MB.
It began a key ring, and was developed into a writing pen.
Printed at full size, any ink pen core should fit nicely through the tube.
It says eternal on one side, as it was intended to be given to customers.
A side note, the support material is DIFFICULT TO REMOVE completely, especially the tube where the pen goes. As such, a 9/64 drill bit or smaller should do the trick.
There is even a hole on back top for a key ring. Also an ink pen cap cut shorter will snugly fit tip.
EDIT:
Added a blank one, one with "FAMILY", "INKED", and "BLACK" to the "ETERNAL" one. Also updated the sketchup file and sized the new ones 25.4x bigger
| Tattoo_Machine_Ink_Pen.skp | 2.9MB | |
| Tattoo_Machine_Ink_Pen_BLACK.stl | 173.1KB | |
| Tattoo_Machine_Ink_Pen_BLANK.stl | 127.8KB | |
| Tattoo_Machine_Ink_Pen_ETERNAL.stl | 166.7KB | |
| Tattoo_Machine_Ink_Pen_FAMILY.stl | 163.8KB | |
| Tattoo_Machine_Ink_Pen_INKED.stl | 163.2KB |
