Remix of one part of IdefixRC's DragonLink V3 Advance mount (which in turn was a remix of Jason-wratten's EzUFHF TX holder).

Part that was remixed is the cradle that holds the DragonLinkV3 main module/box. Instead of having said part attach to a JR Module via a series of GoPro connectors, I designed my piece to 'snap' onto the metal grip/rod thing found at the top rear of the Taranis QX-7 and X9-D as well as many other Transmitters. It can easily be snapped on/off when desired, and is also one solid piece that can be stored relatively flat (as compared the the original design which was very bulky).

I found the original JR module bay method of this design required a very good print for each of its many parts, which involved a lot of support material which was a pain to remove especially since I like to use Taulman Nylon 910. The attached design should have easily removable supports in very un-awkward places.

Note: For optimum clip on/clip off ease, use largely rigid but slightly flexible materials like Nylon etc (but not so floppy like ninja flex where it'd just flop off). Print at whatever infill you like, depending on the material you use to achieve just the right amount of rigidity. For Nylon 910 I'm fine with 95%.