Tap and Die Organizer Tray for Mastercraft Tap and Die Set.
If you have this set, you may have had the stock tray crumble over time. This will fix that. I put some foam on the lid to hold the tools in place.
I printed the lettering by putting in a stop command after the blue was finished and changing to white.
For my printer bed size I had to cut it into 6 pieces, but I have also included the Full Tray for someone who wants to cut it up differently, or has the capacity to print it whole.
Printed in PLA at .2mm height.
UPDATE: Added Upper Left tray with a spot for spare taps, etc.
| Full_Tray.stl | 3.8MB | |
| Lower_Left.stl | 811.6KB | |
| Lower_Middle.stl | 792.3KB | |
| Lower_Right.stl | 623.2KB | |
| Upper_Left.stl | 886.2KB | |
| Upper_Left_With_Spare_Spot.stl | 887.0KB | |
| Upper_Middle.stl | 711.5KB | |
| Upper_Right.stl | 374.8KB |
