Tanares RPG Card Trays 3D Printer Model
The file 'Tanares RPG Card Trays 3D Printer Model' is (stl) file type, size is 71.1KB.
The file 'Tanares RPG Card Trays 3D Printer Model' is (stl) file type, size is 71.1KB.
If you own both the GM-Less Pack and the Power Cards box and if you want to sleeve your cards, then the Power Cards box and its supplied tuckboxes will not fit those sleeved cards anymore. So I created a couple of trays to store all the sleeved cards from both boxes inside the GM-Less Pack box. These are designed for 60micron sleeves... they may not fit larger sleeve sizes.
If you want to store the ringbound adventure book on top this will cause a little bit of lid lift (~10mm) and it may be useful to put a thin lid (not included) on top of the large cards tray to avoid the rings pressing into the cards, but I preferred that over the alternative ... having to store those cards elsewhere.
The included spacer has the same purpose on the side of the mini-size cards.
Print one of each tray... print the spacer if so desired.
| LargeCards.stl | 57.9KB | |
| MiniCards_1Slot.stl | 49.5KB | |
| MiniCards_3Slots.stl | 71.0KB | |
| Spacer.stl | 1.4KB | |
| StandardCards_1Slot.stl | 41.5KB | |
| StandardCards_3Slots.stl | 61.2KB |
