This is a holder for espresso filter holder aka a stand. The advantage is that the filter holder is supported and stray bits of coffee are neatly contained.
The inner diameter of this holder is 51mm and the outer diameter is 59.5mm+/-. There is enough clearance in the device to allow the filter holder to move smoothly in and out of the device. The device was printed in a delta so it can be printed in two parts without any support whatsoever. Four small 3mm machine screws attach the two parts.
| tampertame1.stl | 41.3KB | |
| tampertame2.stl | 108.6KB |
