Tactor Cup And Phone Tray 3D Printer Model
The file 'Tactor Cup And Phone Tray 3D Printer Model' is (STL) file type, size is 239.7KB.
The file 'Tactor Cup And Phone Tray 3D Printer Model' is (STL) file type, size is 239.7KB.
This is cup/mug holder and phone tray I designed to mount on my fathers tractor. Designed to mount onto the right fender of a Kubota L35 using pre-existing holes in the fender. Part is designed to use 5/16"-18 bolts. The model has also been cut into two halves to fit on smaller print beds. The two haves can be glued together with CA or epoxy. I have also included a full size part without mounting features for other uses.
I printed the part in PETG at 20% infill using a Prusa i3. The 2 haves were glued together using CA (cyanoacrylate). I mounted the final assembly on the fender using 2x 5/16"-18 bolts with washers and locknuts. Be sure not to over-tighten and crush/warp the plastic.
Notes:
-Uses 2x 5/16"-18 Bolts
-Mounting hole spacing - 140mm on center
-Cup holder ID - 85mm
-Approx. Tray dims - 196mm long x 118mm wide
| Back_Phone_Tray.STL | 70.2KB | |
| Front-Cup_Holder.STL | 312.1KB | |
| Tray_Full.STL | 319.5KB |
