Tabletop Clip With Hook 3D Printer Model
The file 'Tabletop Clip With Hook 3D Printer Model' is (stl,skp) file type, size is 69.2KB.
The file 'Tabletop Clip With Hook 3D Printer Model' is (stl,skp) file type, size is 69.2KB.
A hook that you can clip onto then end of a horizontal surface, such as a tabletop, bookshelf, etc. to hang things on.
I'm using it for hanging a basket with filament on. I'm using Vik's Y-bearing holder to make sure that it can rotate (see http://www.thingiverse.com/thing:921 ). I put a loop of rope through the two holes that hang over this tabletop clip.
Version 2.3 has some improvements, the hook's lowest point is now nearest to the table. A cord will tend to rest there causing minimum torque on the hook-clip.
It is made stronger at the two 90 angles that have to withstand forces. This is a more efficient use of material and builds faster.
A hole under the hook where no material is required for an adequate strength of the hook.
Version 2.3_thin is simply for a thinner tabletop/shelf.
| Tabletop_clip_with_hook2.2_gap_5_res_10.stl | 57.6KB | |
| Tabletop_clip_with_hook2.3.skp | 38.5KB | |
| Tabletop_clip_with_hook2.3_thin.skp | 38.6KB | |
| Tabletop_clip_with_hook2.3_thin_ok.stl | 57.3KB | |
| Tabletop_clip_with_hook2.stl | 11.4KB |
