This is a Tablet Stand remix based on 3DPrinterNinja's
http://www.thingiverse.com/thing:190062.
Included are a 'Small' and 'Large" version of the stand.
I like the design because it prints relatively quickly and is sufficiently strong to hold a tablet. There are two sizes - small and large that use the same centerpiece. The parts may be glued together or just pushed together so the stand can be disassembled for carrying in a travel bag.
The parts may require a bit of sanding or trimming with an exacto knife to get a snug fit. Strongly recommend that four small stick on pads be added to the bottom to reduce slippage on smooth surfaces.
| LARGE_TABLET_STAND_L.stl | 56.5KB | |
| LARGE_TABLET_STAND_R.stl | 56.5KB | |
| SMALL_TABLET_STAND_L.stl | 37.6KB | |
| SMALL_TABLET_STAND_R.stl | 37.5KB | |
| TABLET_STAND_HOLDER_CENTER.stl | 7.2KB |
