This is an improved (V2) version of the Radiomaster TX16S tablet mount design I uploaded earlier. That design worked well, however it always bothered me that it was relying on a hook point in front of the TX next to the power button, therefore partially obstructing some of the buttons and dials on the transmitter. This version does away with all of that by hooking solidly onto the back of the transmitter, and requiring only two M3 screws to secure the mount in place. The mount fits very snuggly in place, so you may be able to avoid using the M3 screws if the phone or tablet you plan to use is very light.
Print in PLA+ with high quality (0.16mm layer height), 30% cubic infill for added strength, wall line count=6 or above, normal support touching buildplate only, support angle=60. Consider using the "zig-zag" support pattern in Cura to avoid excessive retraction.
| Tablet_Mount_v34.stl | 96.3KB | |
| TX_Rear_Mount_v30.stl | 395.5KB |
