Tablet Mount Kit

Easy to print kit to mount your tablet. Support tablets that have topmost 9mm thickness, width or height doesn't matter. If tablet is used vertically, tablet minimum width is 16cm.

Models optimised for:

• Extrusion width: 0.2075mm, 0.415mm, or 0.83mm
• Layer height: 0.16mm, 0.32mm, or 0.64mm
• Support: not needed (however if you have adhesion troubles with wall mount pieces, you might want to flip them over and try to print flat with all supports enabled)

Models description

Tablet Mount Kit - All.stl

All pieces in one print. Requires 170x108x80mm print area.

Tablet Mount Kit - Quick Wall Mount.stl

Piece to quickly mount your tablet on vertical surfaces. Contains large backing so you can just attach pieces on your tablet, put two-sided tape on both pieces and press the prints against vertical surface. Print two (same piece will fit on left and on right).

Tablet Mount Kit - Table Stand Left.stl
Tablet Mount Kit - Table Stand Right.stl

Piece that place your tablet on 22,5 degrees view angle and keep tablet standing still on table. Left and Right have own pieces.

Tablet Mount Kit - Wall Mount.stl

Piece to mount your tablet on vertical surfaces using screws. Print two (same piece will fit on left and on right)