Mini Foosball table. Two Thirds version (with mods, see below) of Table Soccer by Ace24.
Infill varies depending on the part. Playing surface at 25%. Players at 60%. Nets, end knobs, counters at 50%.
Mods:
Scaled to 2/3
Revised nets with holes
New players
Use of wood dowels instead of printed bars
Modification work done in Sketchup
EDIT (October 13, 2024):
By request, added in files for the control rods. These files will would replace the wood the dowels. There are two versions. One uses a 5.5mm diameter, the other uses a 5.0mm diameter. Depending on your printer and whether you chase the holes in the base with a drill bit, one or the other will fit better. I think I'd print them laying down for best strength, however this will like require supports and a bit of trimming / sanding. Note that I have not tested the game with the printed rods. DvdH.
| base_modified_two_thirds.stl | 198.1KB | |
| control_end_print_4.stl | 46.8KB | |
| control_rods_55mm.stl | 36.8KB | |
| control_rods_5mm.stl | 38.9KB | |
| counter_1.stl | 2.6KB | |
| counter_2.stl | 2.6KB | |
| counter_3.stl | 6.3KB | |
| counter_3_20.stl | 125.1KB | |
| nets_two_thirds_2.stl | 654.8KB | |
| player_print_6.stl | 240.1KB | |
| Rod_end_print_4.stl | 46.8KB | |
| soccer_ball.stl | 59.8KB |
