Table Alligator / Gator Deconstructed with separated eyes to eliminate the need to use paint. This design is based on "Table-Gator" by I-see-3D.
The eyes were carefully separated from the gator head, then enhanced (added some vertical extrusion).
Print the eyes with gold or yellow at 0.1 mm or 0.05 mm, and pause at about 80-90% to swap to a red filament.
Print the head, body, tail with green filament at 0.1 mm.
Glue the eyes to the head to complete the table gator.
| gator_body.stl | 9.6MB | |
| gator_eye_left.stl | 88.5KB | |
| gator_eye_right.stl | 86.4KB | |
| gator_head.stl | 991.6KB | |
| gator_tail.stl | 10.9MB |
