Some time ago I published http://www.thingiverse.com/thing:12478
I was quite proud of my ring designs, and proudly wore one for weeks. . . right up to the point that I flexed my hand just the wrong way and felt the band snap on both sides of my finger. Ever since that time I have been re-designing, printing, wear testing, cycle, rinse, repeat. Now finally I think i have come to a design that is worthy of being published. This ring has a slightly beveled face and thanks to printing in multiple parts is very structurally sound. There is no chance of stress fractures on the sides of the band as it's printed in 2 halves allowing the band to be printed in continous circular layers. The top is beveled as well and has a raised bar in the center that is used to mate to groove on the under side of the ring top face. This is the best Ring design i have compleated in months. Please enjoy it and I look forward to seeing any derivitives that may come out of this design.
I am working on a display of all the Lantern Corp Rings so all those tops are here as well as my Star Trek ring top and a Wolf Ring top.
| r7_black.stl | 48.3KB | |
| R7_BLANK.stl | 41.5KB | |
| r7_blue.stl | 68.1KB | |
| r7_green.stl | 52.0KB | |
| r7_indigo.stl | 52.1KB | |
| r7_orange.stl | 56.2KB | |
| r7_red.stl | 53.3KB | |
| r7_trek.stl | 45.2KB | |
| r7_violet.stl | 53.7KB | |
| r7_white.stl | 60.9KB | |
| R7_WOLF.stl | 54.8KB | |
| r7_yellow.stl | 65.7KB | |
| ring_7-1.stl | 142.7KB |
