Add some light switches and control panels to your diorama or gaming set. Attach these non-functional props to walls or models.
These have been modelled at 100%. Scale as required for your diorama.
Ideally, print using a resin printer. If using a filament printer, then use at least 20% infill.
As required, clean-up and paint your switch. I left mine unpainted. Use thin double-sided tape or adhesive to attach the switches.
| Blank_Plate.stl | 10.4KB | |
| Control_Direction.stl | 2.7MB | |
| Control_Up-Down.stl | 1.1MB | |
| Control_Up-Stop-Down.stl | 1.6MB | |
| Power_Point.stl | 1.1MB | |
| Switch_Double.stl | 1.1MB | |
| Switch_Single.stl | 562.8KB |
