5 Piece Segmented Swimbait I designed in fusion 360 then Airbrushed (Work In Progress )

5 1/2 Inch length.

Uses eye bolts and small nails to create hinges.

Lighter Infill (less than 50) will allow the lure to float while 100% infill causes the lure to sink.

Some tuning might be needed to get these to stay upright in the water but I haven't had much difficulty in doing so (Note lighter lures seem to be just fine with the weight of the hooks being able to keep the lure upright, the 100% infill tends to lay over when the retrieve is stopped, some additional weight at the bottom of the belly resolves this.)

⚠️⚠️Until I can get predetermined hard points inserted into the body I recommend printing this at a dense infill ( more than 30%) this just insures that the eyebolts have sufficient material to hold onto and not just pull out of the lure.⚠️⚠️

CHANGE SLICER UNITS TO MM or else HARWARE WILL NOT FIT!

This thing makes plenty of noise as is but a rattle can be added in future versions.

CHANGE LOG

October 12, 2018 - Changed height of cavity where closed loop of the eye bolt sits to make assembly and alignment easier. Made alignment holes larger so aligning and screwing eye bolts into sections should be easier.

https://www.youtube.com/watch?v=9NCVeAyxofk&feature=youtu.be

Music: https://www.bensound.com