SV Werder Coaster – Untersetzer – 1 Extruder 3D Printer Model
The file 'SV Werder Coaster – Untersetzer – 1 Extruder 3D Printer Model' is (stl) file type, size is 62.8KB.
The file 'SV Werder Coaster – Untersetzer – 1 Extruder 3D Printer Model' is (stl) file type, size is 62.8KB.
Inspired by the YT video of CHEP (search for chep Smooth Two Color Inlay).
The coaster holder can hold 6 coaster with a litte gap on top. A 7th coaster would also fit.
1 Extruder
Very good adhesion needed!
Very good bed leveling and Z-Offset needed
1.1. Load inlet into slicer
1.2. Turn inlet upside down
1.3. center inlet on printing bed
1.4. slice and print
1.5. after print is done make sure bed stays heated to ensure it sticks
1.1. Load coaster into slicer
1.2. Turn coaster upside down
1.3. center coaster on printing bed
1.4. Enable "Z hop when retracted" in slicer with "Z hop height" 0.5mm
1.5. Disable Auto-bedleveling in slicer (e.g. remove G29) to ensure bed leveling is not messuring the printed inlet
1.4. slice gcode
1.5. change filament color and do a good purge out of the previous color
1.6 print
| SVW_Coaster_Holder_v1.stl | 46.6KB | |
| SVW_Coaster_inlet_v1.stl | 46.8KB | |
| SVW_Coaster_v2.stl | 88.9KB | |
| SVW_Coaster_v3.stl | 99.9KB |
