Suspended Landing Gear For RC Airplane 3D Printer Model
The file 'Suspended Landing Gear For RC Airplane 3D Printer Model' is (stl) file type, size is 221.8KB.
The file 'Suspended Landing Gear For RC Airplane 3D Printer Model' is (stl) file type, size is 221.8KB.
Picture shows a slightly different version of the mounting plate, it was originally quite flexible.
Each hole should be drilled out with a 3mm bit before assembly so the joints can move freely. The split pieces scored and combined with superglue, and each joint is connected with a roughly 15mm section of 3mm steel rod. The joints are then capped off by manually extruding plastic into the hole. The wheels are mounted using the same technique, but with a washer on the flat side of the wheel.
Rubber bands are attached as shown in the picture. I like to use dental rubber bands, but any smallish rubber band can work.
The motor mount can fit most motors, but the suspension will only protect a 5 inch or smaller propeller
The ONLY place supports are needed are the rubber band hooks on the mounting plate, and the motor mounting holes
| Large_Arm.stl | 38.0KB | |
| Large_Arm_Split_1.stl | 15.5KB | |
| Large_Arm_Split_2.stl | 30.4KB | |
| Plate_Without_Mount.stl | 78.3KB | |
| Plate_With_Mount.stl | 117.3KB | |
| Small_Arm.stl | 127.3KB | |
| Small_Arm_Split_1.stl | 29.0KB | |
| Small_Arm_Split_2.stl | 100.1KB | |
| Straight_Arm.stl | 55.8KB | |
| Wheel.stl | 291.6KB |
