The file 'Surprising Egg (Drop Inside) 3D Printer Model' is (stl) file type, size is 4.2MB.
This is a remix of the original Surprising Egg (Prints Inside), and is is basically just an egg shell, which you can drop your surprises inside mid-print! You can then crack it open like a real egg.
I would recommend 0,8mm wall thickness (or two lines) as it's already quite tough to break (use a corner of a table or similar to break the egg). The egg has a built in support, which is easier to remove than slicers supports.
4 Different sizes, all with 0,2mm gap between the egg and the support.
Quail Egg 40mm
Chicken Egg 65mm
Swan Egg 120mm
Ostrich Egg 190mm
Check out my other designs here: https://www.thingiverse.com/Superbeasti/designs
Chicken_Egg_65mm_Empty.stl | 3.1MB | |
Ostrich_Egg_190mm_Empty.stl | 3.1MB | |
Quail_Egg_40mm_Empty.stl | 3.1MB | |
Swan_Egg_120mm_Empty.stl | 3.1MB |