Surface Pop Lure 3D Printer Model
The file 'Surface Pop Lure 3D Printer Model' is (stl) file type, size is 4.2MB.
The file 'Surface Pop Lure 3D Printer Model' is (stl) file type, size is 4.2MB.
1 Piece Surface Lure I designed fusion 360 then Airbrushed (Work In Progress )
Uses eye bolts for line tie and hook connections.
Use small drill bit or heat a small nail to start holes for eye bolts to seat for hooks/line attachment.
Lighter Infill 30% or so will allow the lure to float/suspend
⚠️⚠️Until I can get predetermined hard points inserted into the body I recommend printing this at a dense infill (30% or greater) this just insures that the eyebolts have sufficient material to hold onto and not just pull out of the lure.⚠️⚠️
CHANGE SLICER UNITS TO MM or else HARDWARE WILL NOT FIT!
This thing makes plenty of noise as is but a rattle can be added in future versions.
CHANGE LOG
October 18, 2018 - Added a wide version that has a better defined mouth (better pop) and a wider tail that enables the eye bolt to be inserted without difficulty.
https://www.youtube.com/watch?v=9NCVeAyxofk&feature=youtu.be
Music: https://www.bensound.com
| PopLureWide.stl | 4.9MB | |
| pop_lure.stl | 4.4MB |
