Supportless Tux (Linux Penguin Mascot) 3D Printer Model
The file 'Supportless Tux (Linux Penguin Mascot) 3D Printer Model' is (stl) file type, size is 979.5KB.
The file 'Supportless Tux (Linux Penguin Mascot) 3D Printer Model' is (stl) file type, size is 979.5KB.
Fully printable without supports! I chose to use a brim for my prints, but it is not strictly necessary. Mine used 10% infill in a Gyroid pattern in PLA+ at 0.1mm layer height, scaled so it is 100mm tall (around 4 inches) and 2 walls / perimeters. At those settings, it only consumes 38 grams of filament.
Have fun!
Differences of the remix compared to the original model
I made the bottom flat for better adhesion and to make it set better on flat surfaces. I also added a tiny bridge on each flipper at its lowest point to connect it to the body and/or feet so the printer doesn't try to print mid-air. Minor geometry change to upper lip / edge of beak to prevent printing mid-air.
| TuxPrintable.stl | 2.1MB |
