SuperNova inspired by rcFoamFighters SuperNova foam pusher plane.
Wings are 1 layer shells (0.4mm) with 1 layer cross internal structure (0.4mm).
3D files are of the right side of the plane only. You will need to mirror all the parts to make the left side.
See PDFs.
There are only 3D files for half a plane. Youll have to mirror the files to make the other half of the plane. I used Cura slicer to mirror my files when I printed.
Files with names starting with "smaller" is alternative prints for those who got smaller printers (split in 2 at center compared to the larger parts).
Center of gravity: approx 45,5 cm from the tip of the nose.
I got my plane to 1420 grams incl. electronics (4S 1300mAh).
Parts glue toghether using (sandpaper+) superglue.
My setup in the video:
Turnigy 60A speed controller
Turnigy 2836-2350 motor
7x5 propeller? (a bit uncertain)
4S 1300mAh battery
I guess I was using Hextronic D-MG16 (Size: 29 x 11.2 x 29mm)
September 2022:
All the files I have on this plane. Im sorry about the mess and how the 3D files are generated. I was not very skilled at 3D when model was made...
https://drive.google.com/drive/folders/1tKnnYXnQUQU0UTZOr8GMS3xFT52hQa4Z?usp=sharing
Good luck!
| Aileron_Right.stl | 215.5KB | |
| Center_center_Right.stl | 648.3KB | |
| Center_Front_Right.stl | 829.3KB | |
| Center_rear_Right.stl | 712.9KB | |
| Hinges_ailerons_female.stl | 457.3KB | |
| Hinges_ailerons_male.stl | 351.5KB | |
| Inner_Wing_Front_Right.stl | 425.6KB | |
| Inner_Wing_Rear_Right.stl | 530.6KB | |
| Motor_mount.stl | 238.7KB | |
| Outer_Rear_Wing_Right.stl | 538.7KB | |
| Outer_Wing_Right.stl | 818.2KB | |
| Pusher_Plate_Right.stl | 1.1MB | |
| Smaller_Center_center_right_front.stl | 392.4KB | |
| Smaller_Center_center_right_rear.stl | 329.8KB | |
| Smaller_Center_front_right_front.stl | 568.1KB | |
| Smaller_Center_front_right_rear.stl | 428.0KB | |
| SuperNova5-1.pdf | 516.7KB | |
| SuperNova5-3.pdf | 151.7KB | |
| Vertical_Stabilizer.stl | 698.5KB |
